You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 2 Current »

Initially, access the Settings menu and click on Network:


Settings - Network


Click on the Interfaces tab:


Interfaces tab



We will make the following settings in this step:


Some details of the interfaces tab will not be considered in this example, if you want more information, see this page.


Below are the UTM A interface configurations:


Network - Interfaces


LAN configuration of UTM A


Access the physical interface you will use and click []. The following screen will be displayed:


Interfaces - eth1


Next we will detail the panels that we will need to configure.

General Panel


Complete the form as shown below:


Interfaces - General Panel


  • Network Zone: To organize, we name the Zones of all the interfaces that we will use "ECMP";
  • Description: Insert the desired description in order to facilitate the identification of the interface later. Ex .: LAN UTM A.


IPv4


Complete the form as shown below:


Interfaces - IPv4


  • IPv4[]: Mark this checkbox to enable the form;
  • IP Address: Add the IP that will be used by UTM A, in this case, it will be: 192.168.11.1;
  • Mask: Enter the netmask to be used by UTM A.


IPv6


Complete the form as shown below:


Interfaces - IPv6


  • IPv6[]: Mark this checkbox to enable the form;
  • IP Address: Add the IP that will be used by UTM A, in this case, it will be: 2001 :: abcd: c0a8: b01;
  • Prefix: Select the prefix "120".


To save, click [].


This completes the LAN configuration of UTM A. Next we will configure the interfaces that will be used by the routers.


Link with the UTM router 1


Access the physical interface you will use and click []. The following screen will be displayed:


Interfaces - eth2


Next we will detail the panels that we will need to configure.


General Panel


Complete the form as shown below:


Interfaces - General Panel


  • Network Zone: To organize, we name the Zones of all the interfaces that we will use "ECMP";
  • Description: Insert the desired description in order to facilitate the identification of the interface later. Ex.: NETWORK 10.


IPv4


Complete the form as shown below:


Interfaces - IPv4


  • IPv4[]: Check this checkbox to enable the form;
  • IP Address: Add the IP that will be used by the router, in this case, it will be: 10.0.0.2;
  • Mask: Enter the netmask that will be used by the router;
  • Gateway: Define the gateway that will be used by the router, being: 10.0.0.1.


IPv6


Complete the form as shown below:


Interfaces - IPv6


  • IPv6[]: Check this checkbox to enable the form;
  • IP Address: Add the IP that will be used by the router, in this case, it will be: 2001 :: abcd: a00: 2;
  • Prefix: Select the prefix "126";
  • Gateway: Define the gateway that will be used by the router, we will use: 2001 :: abcd: a00: 1.


To save, click [].


This completes the configuration of the interface of one of the routers. Follow the same steps to configure the other links:


Link to the UTM 2 router


Below, an image demonstrating how the UTM 2 Router link should be configured:


Interfaces - UTM 2 Config


Link with the UTM 3 router


Below, an image demonstrating how the link with the UTM 3 Router should be configured:


Interfaces - UTM 3 Config


This finalizes the configuration of the Interfaces in UTM A, next we will configure the static routes.

  • No labels