Network - Interfaces

Standard “Ethernet” physical interfaces are automatically identified by the system. For more information on configuring them, check this page: Interfaces - Interface Ethernet.

In addition, on this panel it is possible to configure the physical interfaces to support the MPLS protocol.

The “Interfaces” tab is made up of six columns: “Interface”, "Address", "Gateway", “Type”, “Zone” and “Action” and in addition, at the top of the screen there is a button for adding interfaces and the actions menu.

Click on the Interfaces tab.

Interfaces tab

The “Interfaces” screen will appear, as shown by the image below:

Network - Interfaces

In this tab we can configure and add physical and virtual interfaces, as listed below:

• Ethernet;
• 3G/4G/LTE;
• ALIAS;
• VIRTUAL;
• VLAN;
• DSL;
• LAG;
• BRIDGE;
• TUNNEL.

This section will cover:

• Registration, Editing and Removal of interfaces;
• Enabling and Disabling Interfaces;
• The particularities of each type of Interface;
• MPLS protocol concept;
• Packet Fragmentation and MTU;
• Etc.

Next, we'll look at the functions located at the top of this panel.